2025 SeaValue Premium - Catalog - Page 150
Electrical
148
ST-BLADE BATTERY TERMINAL MOUNT
FUSE BLOCK
®
®
ML-SERIES HD REMOTE BATTERY SWITCH
Allows high amp switching under load from remote
locations or manually, eliminating long cable runs. Includes
remote control switch # 2145 with lockout slide to prevent
accidental switching. 12V DC coil controls circuits up to 32V
DC and is rated for 500 amps continuous duty and 2500
cranking amps (10 sec.) to handle even large diesel engines.
Magnetic latch only draws current when changing the state
of switch: it draws no current in the "ON" or "OFF" states. 3/8"
Tin plated copper studs.
Item#
Volts
Special
661-7700
12V
275.99 EA
Easy to install 4 ATO /ATC fused circuits mounts directly
on the battery terminal studs. Screw terminals for securing
wires with insulated ring terminals and covers included.
• Screw terminals for securing wires
• Accepts small format labels
• Insulating cover meets ABYC/USCG insulation requirements
• Ignition Protected - for use in gasoline engine compartment
• Includes 4 write-on circuit labels
• Includes four 16-14 AWG and four 12-10 AWG Nylon
insulated ring terminals
• Fuses sold separately
includes a 4-circuit negative busbar
701 SURFACE OR RECESS MOUNTED
CONTOUR MANUAL BATTERY MASTER SWITCH
Item#
661-5024
• Compact, lightweight
• Removable key
• Countersunk recesses for surface mount application
• Standard 21/16" hole cut out (same as standard gauge hole)
• Inside: captive inserts for 3/16" (4.8 mm) nuts providing full
access for cables with no restrictions
• Standard interchange label system
• Molded in high temperature, fiber reinforced plastics
Item#
969-701
Mount
Surface or Recessed
Volts
6-48
Size
23/4" x 23/4" x 3"
Special
50.99 EA
DUAL POWERPOST CABLE CONNECTOR
Provides a termination point for extending the length of
outboard harnesses or other conductors.
• Designed for connecting high amperage conductors
• Also designed for outboard engine installation when
factory cables need to be extended
• One-piece serrated flange nuts ensure correct and secure
connections
• Continuous Rating Not rated-amperage flows between
terminals stacked on post and is determined by wire and
terminals used.
• Voltage Max. Operating: 48V DC
• Mounting Holes Accepts: #10 (M5) Screws
• 2.75''L x 1.75''H
• Rated for 200 amps continuous, 300 intermittent, 1000 cranking
• Panel mount version requires a standard 11/16" cut out
Volts
6-48
Size
23/4" x 23/4" x 3"
Special
61.99 EA
Item#
661-2018
BATTERY MASTER SWITCH
Size
21/4" Dia.
4 Gang
Special
37.99 EA
4-Gang
10 Gang
6-Gang
A closed back design completely insulates power from the mounting surface. Each
screw pair is one isolated circuit. Optional jumpers allow creation of common
circuits. Tin-Plated Brass.
Item#
Gangs
Amps
Fastener
Special
661-2404
4
20
#6
7.99 EA
661-2406
6
20
#6
8.99 EA
661-2504
4
30
#8
9.99 EA
661-2506
6
30
#8
10.99 EA
Tin plated copper bus handles voltage up to 32VDC and is
rated for 100 Amps. #8-32 Screw terminals w/captive star
lock washers ensure a good connection.
Item#
Special
661-2340
30.99 EA
WARNING Reproductive Harm
8 Gang
TERMINAL BLOCK
BATTERY TERMINAL MOUNT BUSBARS
WARNING Cancer Causing Y -
6 Gang
Corrosion resistant construction. Moisture repellent bakelite insulator base. Nickel
plated brass terminals and #8-32 screws. Protective insulator barrier strips. Rated
for 30A @12V.
Item#
Gangs
Size
Special
4
4"L x 15/16"W x 11/16"H
7.99 EA
50-13561
50-13571
6
43/8"L x 15/16"W x 11/16"H
10.99 EA
50-13581
8
51/2"L x 15/16"W x 11/16"H
9.99 EA
10
65/8"L x 15/16"W x 11/16"H
9.99 EA
50-13591
Terminal/Fuse Blocks and Buss Bars
X-
Special
28.99 EA
TERMINAL BLOCK
Allows interruption of the main battery cable for effective
protection against unauthorized use of the boat. Positive
or negative cable can be switched off as required. Key can
be removed in "off" position, current interrupted. Seawaterproof. Tin-plated contacts. U.L. listed. Line connection: 2
screw terminals, M10. Maximum load 12V: 1000 A (10
sec.) 24V: 500 A (10 sec.). Black base, red knob.
Item#
265-002843011
Special
47.99 EA
Connect high amperage cables securely. Includes insulator
caps. 48 volts DC maximum. Posts have no amperage
rating because amperage flows between terminals stacked
on the post and is determined by the wire and terminals
used.
Item#
Size
Stud
Special
5 / " x 7/ ''
661-2002
3.30'' x 1.75''
18.99 EA
16
8
3
7
661-2003
3.30'' x 1.75''
/8" x /8''
18.99 EA
4 POSITION - OFF/1/BOTH/2
The 701-S is the most compact selector switch available
on the market. Housed in the same manner as the 701 and
includes the same removable side plates and back cover.
While BEP Marine foremost recommends isolated battery
systems as outlined with our distribution clusters, the 701-S
offers a simple economical way of separating two batteries.
Mount
Surface or Recessed
Amps
30A
POWERPOST CABLE CONNECTOR
701-S MINI BATTERY SELECTOR SWITCH
Item#
969-701S
Description
ATO / ATC Fuse Block Kit
Z-
WARNING Cancer and Reproductive Harm
See www.P65Warnings.ca.gov
